CathStack
Catheter shaft design software

From layer stack to toleranced OD, mechanics and 3D model.

CathStack calculates every diameter of a layered, multi-lumen catheter shaft with its tolerance spread, predicts stiffness and burst with their bands, tells you which tubes to buy, and builds the parametric model in Onshape.

Windows and macOSRuns locally, no telemetryOnshape integration

CathStack demo: 8.5 Fr bidirectional steerable sheath (illustrative)
4
stack-up methods: worst case, RSS, modified RSS, Monte Carlo
12
mechanical results, each with a tolerance band
1 click
to a parametric Onshape model with braid and coil wires
70
cited material grades in the library
How it works

Describe how the shaft is built. CathStack does the arithmetic.

No spreadsheets to maintain. Every number updates as you type, and every result carries its tolerance band.

01 / BUILD

Stack the layers

Mandrel, liner, braid or coil, reflowed jackets, pull-wire lumens, heat shrink. Each with nominal and asymmetric tolerances, and as many segments along the shaft as you need.

02 / CHECK

Read the spread

OD, lumen and walls by worst case, RSS and Monte Carlo, with Cp/Cpk against your limits; stiffness, burst and kink with their bands.

03 / SHARE

Model and report

Push the design to Onshape as an editable parametric part, and export a PDF report and CSV for your design review.

Live tolerances

Change one tolerance, see the consequence

In the demo, loosening the outer jacket's OD tolerance from ±0.001″ to ±0.003″ drops the OD Cpk from 1.35 to 0.72, and the design fails its 4 mm ceiling. You see it as you type, not after the build.

Watch the chapter →

Status changes to FAIL and Cpk drops to 0.72 after loosening a tolerance
Mechanics with bands

Stiffness, burst and kink, toleranced

Bending, torsional and axial stiffness, burst and collapse, tensile, kink radius and column load run through the same tolerance engine as the OD, segment by segment along the shaft.

How the models were validated →

Mechanical performance tiles with Monte Carlo bands
Onshape

Real geometry, not a picture of it

Generate the shaft as a parametric Onshape model: layers, braid and coil wires, lumens and material colours. One segment with cut-back lengths, or the whole shaft.

See the gallery →

The stack-up cross-section next to the generated Onshape model
Sample output

Read the reports from the demo

One PDF per segment of the demo sheath, exactly as CathStack exports them.

Page 1Page 2Page 3

Proximal shaft

19 pages · PDF · 146 KB

Open the sample report
Page 1Page 2Page 3

Transition

19 pages · PDF · 146 KB

Open the sample report
Page 1Page 2Page 3

Deflectable tip

19 pages · PDF · 146 KB

Open the sample report

See CathStack on your own design

Send a construction you're working on, and we'll walk through it live.